Nova 720 Dive Light: Setup, Beam Use and Buying Tips for Divers
Learn how to choose, set up and use a nova 720 dive light safely. Covers beam considerations, battery care, mounting and common mistakes for women divers.
Updated November 2026
A nova 720 dive light is a handheld underwater light that many divers use for night dives, wreck penetration and general low-visibility work. This guide explains what to check before you buy, how to set the light up for a dive, and how to avoid the mistakes that leave divers in the dark. Use it as a starting point, then compare the manufacturer’s current specifications for the exact version you are considering.
Check Your Dive Needs Before You Buy
Start with the type of diving you do most. A light for shore night dives, where you need to scan the bottom and find marine life, has different requirements from one used for cave or wreck penetration, where a backup light is essential. Women divers who often dive in cooler water should also think about glove compatibility, since controls that are easy to press with bare hands can be hard to operate with thick gloves.
Shopping for one? See our guide: 5 Best Scuba Dive Light Picks: Top Options Compared (2026).
Look at the light’s beam type and output as the manufacturer describes them. A focused beam reaches farther, which helps when scanning open water, while a wider beam is better for close-range work. For a broader overview of how dive lights differ, see Top 7 Best Technical Dive Light Picks Compared for Serious Divers.
Set Up the Light Before Each Dive
A consistent pre-dive routine prevents most light failures. Work through these steps on the surface, not at depth:
- Confirm the battery is fully charged and the O-ring is clean, dry and seated correctly.
- Turn the light on and check that it produces the expected beam at the setting you plan to use.
- Attach the light to your wrist, BCD or primary light clip so it cannot drop during the dive.
- Carry a backup light of at least similar capacity, and confirm it works too.
If you use a wrist-mounted setup, the strap should sit snug enough that the light does not slide, but loose enough that you can flex your wrist. Wrist Mounted Dive Light: 7 Tips for Choosing and Using One Safely covers strap fit in more detail.
Use the Beam and Manage Battery Life
Match the beam setting to the task. Use the highest output only when you need it, such as scanning for a lost buddy or reading a dive slate in murky water. Lower settings extend run time and reduce backscatter, the glare caused by light reflecting off suspended particles. Many divers find that a moderate setting is enough for navigating a reef.
Track how long the light runs on each setting. Manufacturers publish run-time figures under test conditions, but real-world results depend on temperature, battery age and how often you cycle the light on and off. Plan your dive so you finish with a comfortable reserve, and recharge or replace batteries on a regular schedule rather than waiting for the light to dim.
Recommended gear
- Dive light lanyard or wrist strap: keeps the light secured so you can use both hands for equipment and signals. View on Amazon
- Silicone O-ring grease: helps maintain a watertight seal on the light’s housing when applied sparingly. View on Amazon
- Backup dive light: a second light gives you a safe way to finish a night dive if the primary fails. View on Amazon
Common mistakes
- Skipping the pre-dive test, then discovering a flat battery at depth.
- Running the light at maximum output for the whole dive, which shortens run time quickly.
- Over-tightening or under-greasing the O-ring, both of which can cause leaks.
- Rinsing the light only once, leaving salt crystals that wear seals over time.
- Carrying no backup light on night or penetration dives.
FAQ
Is a nova 720 dive light suitable for night diving?
It can be, provided you choose the right beam setting and carry a backup light. Confirm the exact model’s specifications against your planned dive profile before relying on it.
How often should I charge or replace the battery?
Charge before every dive and follow the manufacturer’s guidance on battery replacement. Replace batteries that no longer hold a full charge, since weak cells can fail at depth.
Do I need a dive light for daytime diving?
Often not for shallow, clear-water dives, but a light helps reveal red tones that disappear with depth and makes it easier to see into crevices and under ledges.
Conclusion
A well-chosen nova 720 dive light works best when you match its beam to your dives, test it before every descent and keep a backup ready. Good maintenance, especially around the O-ring and battery, prevents most problems. Review the manufacturer’s current guidance and consult an experienced instructor if you are unsure how to use your light for a specific dive type.
Related reading
Ready to choose one?
