We research and compare products using published specifications, features and owner feedback. When you buy through our links, we may earn a commission. As an Amazon Associate I earn from qualifying purchases. Learn more›

Scubapro NovaLight 720 Dive Light: Setup, Beam Use and Buying Tips

Learn how the Scubapro NovaLight 720 dive light works, how to set it up and use its beam well, and what to check before buying one for diving.

Updated November 2026

The Scubapro NovaLight 720 dive light is a compact, handheld underwater light that many divers use as a primary or backup source for night dives, wreck penetration and low-visibility work. This guide explains what to check before you buy, how to set the light up before a dive, and how to use its beam so you see more and conserve battery. It also covers the mistakes divers commonly make with dive lights of this type.

Step 1: Confirm the Light Fits Your Diving

Before you buy or use a NovaLight 720, decide what you need it for. A light for a shallow reef night dive has different demands than one for a cave or deep wreck. Think about how long your typical dive lasts, how dark the water usually is, and whether you need a primary light or a backup.

Shopping for one? See our guide: 5 Best Scuba Dive Light Picks: Top Options Compared (2026).

Also consider beam type. A wide beam lights up a larger area and works well for general navigation and checking your buddy, while a narrower, more focused beam reaches farther in clear water. If you are unsure which suits you, our guide on Wide or Narrow Beam Dive Light: Which Should You Choose? walks through the trade-offs.

Step 2: Prepare the Light Before Each Dive

  1. Check the battery or charge level and charge it fully the night before.
  2. Inspect the O-ring and lens for debris, hair or scratches. Rinse the light in fresh water if it has been in salt water.
  3. Confirm the switch works and cycles through the modes you expect to use.
  4. Mount the light securely. A wrist or hand lanyard keeps it from drifting off during fin kicks.
  5. Carry a backup light or a small spare, especially on night dives.

Always follow the manufacturer’s instructions for charging and O-ring care, since seal failures are a common cause of water damage. If you are unsure about a fault, have a qualified dive shop check the light before diving with it.

Step 3: Use the Beam for Better Visibility

Good beam use matters as much as the light itself. Point the beam slightly ahead and to the side of your path rather than straight into the particles in front of you. Backscatter from suspended particles, called marine snow, can make a light useless if you aim it directly at your face.

Use the lowest brightness that still lets you see clearly. This extends run time and reduces glare. Switch to a higher setting only when you need to inspect something specific or signal a buddy.

Step 4: Plan Battery Use and Signals

Track your light’s run time on each dive so you know roughly how long a full charge lasts at the settings you use. Plan to end your dive with a reserve of light, not with a near-empty battery. For a quick reference on how wider or narrower beams affect coverage, see Underwater Kinetics Dive Light: How to Choose and Use One Well.

Agree on light signals with your buddy before the dive. A slow sweep usually means “look at me,” while a rapid flash often means “attention needed.” Using the same signals every time avoids confusion at depth.

Common Mistakes to Avoid

  • Aiming the beam straight ahead in murky water, which creates backscatter.
  • Running the light on its highest setting for the entire dive.
  • Skipping O-ring checks after a dive, which can let water reach the electronics.
  • Diving with an uncharged or partially charged light.
  • Relying on a single light for a night dive with no backup.

A spare wrist or hand lanyard lets you carry the light securely and free your hands for navigation and tasks underwater. View on Amazon

A small O-ring lubricant and cleaning kit helps keep seals in good condition between dives. View on Amazon

A protective case or pouch keeps the light safe during transport and storage on the boat. View on Amazon

FAQ

Is the Scubapro NovaLight 720 suitable for night diving?

Many divers use compact lights of this type for night dives, but you should always carry a backup light for any dive where you depend on artificial light. Check the run time and beam output against the conditions you expect to dive in.

How should I store the light between dives?

Rinse it in fresh water, dry it thoroughly and store it charged or at the level the manufacturer recommends. Keep it away from direct sun and extreme heat.

Should I consult a professional before diving with a dive light?

Yes. If the light shows a fault, leaks or behaves unexpectedly, have a qualified dive professional or the manufacturer inspect it before you dive. Dive safety decisions should be made with proper training and guidance.

Conclusion

The Scubapro NovaLight 720 dive light works best when you match it to your diving, prepare it carefully before each dive, and use its beam with restraint. Check the seal, plan battery use and carry a backup. With those habits in place, you will see more, use less power and dive with greater confidence.

Miles Sinclair

About Miles Sinclair

Miles Sinclair is part of our editorial team and reviews and edits our scuba gear for women guides, checking product details against manufacturer specifications and owner feedback.

About the author

Miles Sinclair
Miles Sinclair

Miles Sinclair writes reviews and buying guides for Scuba Women.