How to Clear Dive Mask Water: A Step-by-Step Guide for Divers
Learn how to clear dive mask water in seconds with the tilt-and-exhale method. Simple steps, common mistakes to avoid, and tips for staying dry underwater.
Updated November 2026
To clear a dive mask, you tilt your head back slightly, press the top of the mask frame, and gently exhale through your nose. This pushes water out of the bottom of the mask while you keep your eyes open and your vision clear. With a little practice, most divers can clear a mask in a few seconds without surfacing.
Why Water Gets Into Your Mask
Water usually enters at the bottom edge of the skirt, especially when the mask doesn’t sit flush against your face. Small gaps near the cheekbones, the nose bridge or the forehead also let water seep in as you descend and pressure builds. Hair caught under the skirt or a loose strap can make the problem worse.
Shopping for one? See our guide: Dive Mask Corrective Lens: 4 Best Picks for Clear Underwater Vision (2026). For a deeper look, Dive Mask Stick on Lenses: How to Add Clear Vision to Your Mask covers this in detail.
Step-by-Step: The Tilt-and-Exhale Method
- Hold steady and stay neutrally buoyant. Keep your body level so you aren’t kicking toward the surface or sinking.
- Tilt your head back. Angle your face toward the surface so the bottom of the mask sits lower than the top.
- Press the top of the frame. Hold the upper part of the mask firmly against your forehead to keep it sealed.
- Exhale gently through your nose. Breathe out steadily. The air pushes water down and out through the bottom skirt.
- Check your view. If water remains, repeat the exhale. Avoid blowing hard, since a forceful blast can break the seal.
Clearing a Mask with Water Pressed Into the Frame
If the mask has partly flooded and you can’t clear it with one exhale, you may need to break the seal briefly to let water escape. Lift the bottom edge of the skirt away from your face, exhale through your nose, then press the mask back on. Keep your eyes closed while you do this if it helps you stay calm. Practice this in shallow water first so it feels routine.
Preventing Leaks Before You Descend
Most flooding comes from a poor fit or a skirt that isn’t seated correctly. Before entering the water, put the mask on without the strap, inhale gently through your nose to create suction, and check that the skirt stays put. Tighten the strap so it sits behind your head, not on your hair. Pull hair away from the skirt, and make sure no fibers or debris sit between the silicone and your skin. Consider a mask defog or anti-fog product to reduce fogging, which often leads to frequent clearing.
Practice in Shallow Water
The best time to learn mask clearing is in a pool or calm, shallow water before you’re deeper in open water. Repeat the tilt-and-exhale method until it becomes automatic. Practicing for five to ten minutes per session builds the habit and gives you confidence in case water appears on a real dive.
Common Mistakes
- Breathing out through your mouth instead of your nose, which doesn’t push water out effectively.
- Holding the mask too loosely, so the top of the frame lets air and water in.
- Blowing too hard, which can break the seal and let more water in.
- Tightening the strap too much, which can distort the skirt and cause leaks.
- Surfacing to clear the mask instead of practicing the method underwater.
Recommended Gear
- Silicone mask defog helps reduce fogging so you clear the mask less often. View on Amazon
- Replacement mask strap can improve fit if the original strap no longer holds the skirt flush. View on Amazon
FAQ
Can I clear my dive mask if it’s full of water?
Yes. Use the tilt-and-exhale method, and if needed, lift the skirt briefly to let water escape before pressing the mask back on. Practice this in shallow water so it feels familiar.
Why does my mask keep flooding?
The most common causes are a poor fit, hair under the skirt or a loose strap. Check the seal before each dive and adjust the strap so it sits behind your head.
Should I clear my mask by blowing hard?
No. A gentle, steady exhale through the nose works better and is less likely to break the seal. Forceful blowing often lets more water in.
Conclusion
Clearing a dive mask comes down to a gentle exhale through the nose while you tilt your head back. A good fit and careful strap adjustment prevent most leaks. Practice in shallow water until the method feels automatic, and consult a certified dive instructor if you keep struggling with flooding.
Related reading
- Prescription Dive Mask Perth: How to Get Clear Underwater Vision
- Prescription Dive Mask Australia: How to Get Clear Vision Underwater
- Prescription Dive Mask Adelaide: How to Get Clear Underwater Vision
- Trident Scuba Dive Mask Seal Stick: How to Fix and Prevent Leaks (2026)
- Tinted Dive Mask vs Clear: Which Lens Suits Your Diving? (2026)
Ready to choose one?
